Escape Series 1: The Car

- Examine the console in the bottom middle of the front seat
- Open the lid and take the flashlight
- Turn around to the back seat
- Examine the console in the bottom middle again
- This time you will see the back of the console, the ashtray
- Pull out the lighter and take the small key underneath
- Return to the back seat
- Click the bottom right or bottom left area of the screen to look at the backseat floor
- Examine the floormat on the right and take the knife from underneath
- Return to the backseat
- Click the ceiling area, above the rear window
- Use the knife to remove the wiring guide from the ceiling
- Go to the front seat
- Examine the glove box and use the small key to open it
- Take the batteries and electrical tape
- Combine the batteries and flashlight
- Return to the backseat
- Use the knife to cut the straps on each side of the cushion
- Click the cushion to set it aside
- Click the small dark gray area behind the cushion
- Enter "E40" on the numberpad (this can be seen from examining the instrument panel in the front seat. The E on the gas gauge is circled, and the speedometer is stuck on 40)
- Use the flashlight with batteries to see
- Break the cracked light cover on the left with either the knife, screwdriver, or hammer
- Take the key that falls on the floor
- Return to the front seat
- Examine the pedals underneath the steering wheel
- Use the screwdriver to open the panel underneath the steering wheel
- Following the wiring guide, only connect the red, blue, green, and gray wires. Use the electrical tape on each connection
- Examine the instrument panel behind the steering wheel
- Use the key in the ignition switch to turn the car*s electricity on
- Return to the area with the pedals, and press the trunk release button

Нажмите для просмотра прикрепленного файла

- Exit through the trunk